GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-35
PRELIMINARY
9.) To return the alignment block to its position on the support pin, raise the support arm and insert the
alignment block to its position above the securing bolt, see Figure 8-35.
10.)Tighten the securing bolt.
11.)Tap the alignment block downwards until it is firmly positioned on the securing pin - Figure 8-43.
12.)Return the roller-screw to secure the Alignment Block - Figure 8-44 and return the lower roller-screw
to its position.
13.)Reconnect the earth lead.
14.)Return the Upper Monitor Arm cover (previously removed) to its position on the Upper Monitor Arm.
15.)Return the Keyboard Assembly as described in the “Keyboard Assembly Installation Procedure” on
page 8-42.
Figure 8-43 Tapping the Alignment Block Downwards into Position
Figure 8-44 Alignment Block showing Upper Roller Screw
To Next Page
Loading...
