GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-157
PRELIMINARY
8-6-10 TR32 and RFI Boards Replacement Procedure (cont’d)
7) Loosen and remove the 10 Phillips screws that fasten the RFI board in position - Figure 8-192.
NOTE: There are 2 long, 2 medium length, 2 short, and 4 very short screws.
8) Disconnect the power cable from the RFI Board - see Figure 8-193.
9) Disconnect the BEP-to-RFI flex cable from the cable connector on RFI Board, as shown in Figure
8-193 below.
Figure 8-192 Removing Securing Screws from RFI Board
Figure 8-193 Disconnecting the Cables from the RFI Board
BEP-to-RFI
Power Cable
Flex Cable
To Next Page
Loading...
