GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-158 Section 8-6 - Lower Section Components Replacement Procedures
PRELIMINARY
NOTE: Although the securing screws have been removed from the RFI Board (step 7), it is still secured
on the cabinet cage assembly by way of a metal spline. It is necessary to perform the next step
in order to release the RFI Board and so facilitate its removal from the cage assembly.
10) Using a flat screwdriver, push down the metal spline to release the RFI Board from the fastened
position, as shown in Figure 8-194.
11) Carefully lift the RFI and TR32 Board out of the cage assembly - together with the Heat Sink - as
shown in Figure 8-195 below.
(The RFI and TR32 Boards are seated together in the system as one unit).
NOTE: The Heat Sink pad on the RFI Board (shown in Figure 8-195, above) is adhered in position and
should be re-used.
Figure 8-194 Releasing the Spline
Figure 8-195 Removing the RFI and TR32 Boards
To Next Page
Loading...
