Quantitative Analysis
388 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
To move a dynamic anchored sample area
1. Press TRACKBALL until the Scroll trackball assignment is
selected.
In these frames the
sample area is
marked with an an-
chor.
2. Using the trackball, browse through the cineloop to display
one of the frames where the sample area was anchored.
3. Press
TRACKBALL until the QA trackball assignment is
selected.
4. Trackball to the sample area to move, in one of the
Cineloop windows.
5. Press
SET.
The sample area is unanchored.
6. Drag the sample area to a new location.
7. Press
SET to anchor the sample area to the new location.
Zooming in the Analysis window
1. In the Analysis window, press and hold down the SET key
while dragging the trackball cursor to define the zooming
area.
2. Release the
SET key.
The selected area is displayed in the Analysis window.
To unzoom
1. Press UPDATE MENU in the trackball area on the control
panel.
The System menu is displayed.
2. Trackball to Unzoom.
3. Press
SET.
To Next Page
Loading...
