GE Vivid S6 - Frame Disabling; Disabling Frames; Re-Enabling All Frames

Quantitative Analysis
390 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Frame disabling
Frame disabling excludes the actual frame from the cineloop
display. Frame disabling is available only with contrast data.
Disabling frames
To re-enable a
frame: Press
SELECT on the cor-
responding frame
marker.
1. Trackball to the frame marker of the frame to disable
beneath the Analysis window (see Figure 8-2).
2. Press
SET to disable the frame.
The frame marker turns red.
disabling successive frames at a time
To re-enable succes-
sive frames: press
and hold down
the
SELECT key
while dragging the
cursor over the
frame markers.
1. Press and hold down SET while dragging the cursor over the
frame markers of the frames to disable.
The frame markers turn red.
ECG triggered frame disabling
In a multi-cycle acquisition, the user may deselect all frames in
all heart cycles but a selected one. This function can be used
for example to select a particular systolic frame for each heart
cycle.
1. Scroll through the cineloop to identify the cardiac phase to
analyze or identify the cardiac phase on the ECG trace.
2. Trackball to the frame marker of the frame of interest in one
of the heart cycles (see Figure 8-2).
3. Press
UPDATE MENU.
The System menu is displayed.
4. Trackball to ECG triggering.
5. Press
SET.
All frames in all heart cycles are disabled except for the
selected and corresponding frames in the other heart
cycles.
Re-enabling all frames
1. Trackball the cursor to the Frame marker axis.
2. Press
UPDATE MENU in the trackball area on the control
panel.
The System menu is displayed.
3. Trackball to Enable all frames.
4. Press
SET.