4D and Multi-plane Modes
6-26 Vivid S70 / S60 – User Manual
BC092760-1EN
01
2. On the Touch panel, select the crop plane to adjust.
3. The adjustment of the crop plane is done with the trackball.
Press Select to toggle the trackball function between
translation (Transl) and rotation (Rot).
• Transl: translates the crop plane into the volume.
• Rot: rotates the view plane around the volume
rendering.
To rotate the crop plane, press Rotate crop on the
Touch panel and use the trackball to apply rotation.
Press Rotate crop again when done.
4. Use the Rotate red and Rotate blue controls on the Touch
panel to fine tune the adjustment of the crop plane.
The Rotate Red control rotates the crop plane about the red
indicator in the center of the crop plane. Similarly, the
Rotate Blue control rotates the crop plane about the blue
indicator. The Spin Red&Blue control changes the
orientation of the red and blue indicators, to facilitate
cropping in oblique angles.
5. Other possible adjustments:
• Press Flip crop to remove the data on the other side of
the current crop plane. The viewing direction is flipped
180 degrees.
• Press Parallel crop to add a crop plane parallel to the
current crop plane. This setting can be useful for valves
and shunts renderings.
When using Parallel Crop, both crop planes move
together, when translating and rotating. The thickness of
the parallel crop is adjusted using the Thickness
control.
To remove parallel cropping, press Parallel Crop again.
Press Reset Active to undo the adjustments made on the
current active crop plane.
Press En face view to display a straight forward view of the
active crop plane.
6. On the Touch panel, select another crop plane and make the
required adjustments as described above.
NOTE: Pressing down a button containing a check mark will make
the corresponding existing crop plane active. Pressing a
button without a check mark will introduce a new crop plane,
and make it active.
7. To remove crop planes:
To Next Page
Loading...
