4D Auto MVQ
Vivid S70 / S60 – User Manual 8-75
BC092760-1EN 01
Approval
Press Approve and exit to store the measurements shown in
the Worksheet tab of the measurement table.
The measurements are transferred to the Worksheet.
To exit without approving, press Cancel.
NOTE: Measurements that are not approved will not be saved.
The 4D Auto MVQ tool involves partly automated steps
(automatic segmentation of MV). There is an inherent risk that
these steps may fail. Verify the correctness of the borders,
tracked points and 3D model using the displayed verification
graphics in the tool before approving.
To Next Page
Loading...
