Connectivity setup
Vivid T9/Vivid T8 – Basic Service Manual 3-45
5795591-100 English Rev. 3
3-9-2-2 To Add a Server in the Server Config List(continued)
2. Add the server’s name in the Server Name field.
3. Add the server’s IP address in the IP-Address field.
4. Select Check to verify that the server is found.
This check is a network Ping. A symbol to the right for the Check
button indicates the result:
• A green check mark next to the Check button indicates that
the IP-Address is found on the network.
• A red check mark indicates that the IP-Address can’t be
found.
Possible reasons:
• No network connection between the ultrasound system and
the server.
• The wrong IP address.
3-9-2-3 To Modify the Setup for a Server in the List
NOTE: Both the pre-defined servers and new servers can be modified.
Follow this procedure to modify the setup for a server in the
list:
1. Highlight the server you want to modify.
2. Select Modify.
3. Update the information as needed.
4. Select Check to verify that the server is found.
This check is a network Ping. A symbol to the right for the
Check button indicates the result:
• A green check mark next to the Check button indicates
that the IP-Address is found on the network.
• A red check mark indicates that the IP-Address can’t be
found.
Possible reasons:
• No network connection between the ultrasound system
and the server.
• The wrong IP address.
5. Select OK to confirm your new settings, or Cancel to leave
without doing any changes.
To Next Page
Loading...
