Connectivity setup
Vivid T9/Vivid T8 – Basic Service Manual 3-51
5795591-100 English Rev. 3
3-9-4-3 Verify the Connection to a Device
1. Select (highlight) the device you want to verify the
connection.
NOTE: You can only check one device at a time.
Figure 3-36. Verify Connection to a Device
2. Select Check to start the verification process of the
connection to the device.
The verification process takes some time to run.
When done, a pop-up is displayed on the screen. It gives
you the status for the check.
In the illustration below, the message indicates that the
pinging of the server worked fine (line1), but the application
on the server didn’t respond (line 2).
Figure 3-37. Information - Check Status
Select OK to close the pop-up window.
A sign is displayed next to the Check button, indicating if
passed or failed .
NOTE: If the Check button fails immediately, the AE Title is
probably wrong. If the Check button fails after a long time
(corresponding to the timeout), the IP address or Port
Number is probably wrong.
To Next Page
Loading...
