System Setup
3-54 Vivid T9/Vivid T8 – Basic Service Manual
5795591-100 English Rev. 3
3-9-4-4 Dicom Storage Setup(continued)
• Image Settings
The pull-down menu gives these choices:
• Jpeg - JPEG/JPG compression (Default). JPEG is not
lossless.
• None - (un-compressed data with huge files).
NOTE: If you are using compression None, it is strongly
advised to reduce Frame Rate to 25 or 30 to avoid
truncating loops.
• Rle - Run Length Encoding. This is lossless
compression.
• Quality % - Set the wanted quality %. Default value is
95%.
If files are stored with a quality lower than 95% they will
occupy less space, but loose some quality.
NOTE: Setting the quality % too low may add too much artifacts
to the images that they cannot be used for diagnosis.
If files are stored with a quality above 95%, the files will
grow much larger without almost no quality change.
• Retry
Max# - The number of times the software will try to
connect if the connection doesn’t succeed the first
time(s).
Interval - The interval in seconds between each attempt
to connect.
Timeout- Adjust the time-out setting.
The retry settings can be used to make jobs retry on
bad networks. There is no need to set retries for mobile
(off-line) use.
In Image Settings, setting compression to None may lead to
very long transfer time and loops larger than 500s frames will
be trucated. In case it happens, a warning is displayed on the
screen.
To Next Page
Loading...
