Connectivity setup
Vivid T9/Vivid T8 – Basic Service Manual 3-59
5795591-100 English Rev. 3
3-9-5-2 Configurable Remote Path User
NOTE: The default User/Password is always used as primary log in
credential. No attempt is made to use the secondary user if log
in succeeds using the primary.
NOTE: The configurable User/Password is used for all remote paths
configurable throughout the system as secondary log in
credential.
NOTE: The User on the remote share must have all rights/controls for
the shared folder.
Follow these steps to set up a Secondary Remote Path User:
1. Press Config (F2) on the control panel and log on as
administrator if required.
2. Select Connectivity -> Remote.
The Remote sheet is displayed.
Figure 3-44. The Tools sheet
3. Enter the User and Password in the respective fields.
NOTE: The filed User can either be on the form of username or
domain\username.
To Next Page
Loading...
