GE Voluson 730Pro - Delete Full Backup (Presets, Configurations & Application Settings); Full Backup Delete

GE MEDICAL SYSTEMS - KRETZTECHNIK DRAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
Chapter 4 - Functional Checks 4-39
4-5-4 Load Full Backup (Presets, Configurations & Application Settings) (cont’d)
8.) Click the NEXT
button and then select YES to start, or NO to cancel the restore procedure.
After restoring the data, the Voluson® 730Pro / 730ProV reboots and the application starts again.
4-5-5 Delete Full Backup (Presets, Configurations & Application Settings)
1.) Press the UTILITIES key on the control panel. The menu area changes to the Utilities menu.
2.) Select the SYSTEM
item from the menu area to activate the setup desktop screen.
3.) Select the
BACKUP page and click the DELETE button of the “Full Backup” group.
4.) Choose the Destination (e.g., HDD = Hard disk).
5.) Click on the backup to be deleted (additional information is displayed in the table).
6.) Select the DELETE
button.
Figure 4-33 Start Restore Backup now?
WARNINGWARNING
When clicking “YES”, the current data on the system will be permanently replaced by
the data of the backup and can not be restored!
Figure 4-34 Full Backup Delete
WARNINGWARNING
There is no “ UNDO” function for this action!
choose destination
select backup
select Delete