GE MEDICAL SYSTEMS - KRETZTECHNIK DRAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5-15
5-2-4-10 Sonoview write mode (store Image to Sonoview)
1.) CRS
Not used
2.) CPR
Not used
3.) CKV - DMA section
Not used
4.) CKV - Video section
Not used
5-2-5 Description of Software Options
To activate the software options:
1.) Press the UTILITIES
key on the control panel. The menu area changes to the Utilities menu.
2.) Select the SYSTEM
item from the menu area and then select the OPTION page.
For details see: Basic User Manual Voluson® 730Pro / 730ProV, chapter 17.3.4
NOTE: Additional options are not yet implemented in the Voluson® 730Pro / 730ProV.
5-2-5-1 Real Time 4D
Real Time 4D mode is obtained through continuous volume acquisition and parallel calculation of 3D
rendered images. In Real Time 4D mode the volume acquisition box is at the same time the render box.
All information in the volume box is used for the render process. In Real Time 4D mode a “frame rate”
of up 16 volumes/second (at Voluson® 730Pro V up to 10 volumes/second) is possible. By freezing the
acquired volumes, size can be adjusted, manipulated manually as known from the Voluson 3D Mode.
BT Version:
Some Software Options may be considered standard, or are only available at systems that were
upgraded to BT´05 (SW 5.x.x).
NOTICE
Not all Options are available on the Voluson® 730Pro V (marked with * in the following sections of the
Service Manual).
Table 5-2 Software Options
SW-Options Description
1
Real Time 4D 5-2-5-1 Real Time 4D
2
DICOM 5-2-5-2 DICOM
3
CrossBeam-CRI* 5-2-5-3 XBeam CRI - CrossBeam Compound Resolution Imaging*
4
VOCAL II* 5-2-5-4 VOCAL II - Virtual Organ Computer-aided Analysis*
5
RT_4D_Biopsy* 5-2-5-5 Real Time 4D Biopsy*
6
SRI* 5-2-5-6 SRI - Speckle Reduction Imaging*
7
STIC* 5-2-5-7 STIC (Spatio-Temporal Image Correlation)*
8
VCI* 5-2-5-8 VCI - Volume Contrast Imaging*
9
TUI* 5-2-5-9 TUI - Tomographic Ultrasound Imaging*
To Next Page
Loading...
