GE Voluson 730Pro - Capturing a Screen; Export Log’s and System Data; Screen Captures and Logs

GE MEDICAL SYSTEMS - KRETZTECHNIK DRAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-5
Section 7-4
Screen Captures and Logs
There may be times when the customer or field engineer will want to capture a presentation on the
screen so it may be recovered by the OnLine Center.
This is accomplished by saving the image(s):
A.) to SonoView and export them (as jpg, bmp or tiff ) to DVD/CD+(R)W or MO-disk
B.) as jpg and bmp to D:\export by pressing the ALT
+ P key on the alphanumeric keyboard
C.) creates one snapshot (Alt-D.bmp) + “Full Backup” of the System state (fullbackup -> fb1) saved on
D:\export by pressing the ALT
+ D key on the alpha-numeric keyboard.
7-4-1 Capturing a screen
The following is the generic process to capture any screen from the scanner.
3.) Select the stored image(s) in Sonoview (Exam List) and EXPORT the image(s) to DVD/CD+(R)W
or MO-Disk (jpg, bmp or tiff).
7-4-2 Export Log’s and System Data
There are two possibilities to export system data (and log´s):
1.) by pressing the ALT + D key to save a snapshot and “Full Backup” of the System state;
see: Section 7-4-2-1 on page 7-6
2.) via the EXPORT SYSTEM DATA
button in the System Setup SERVICE page;
see: Section 7-4-2-2 on page 7-7
1.) Navigate to and display the image/screen to be captured.
2.) Press the SAVE 2D
key on the control panel and save the image to Sonoview.