GE MEDICAL SYSTEMS - KRETZTECHNIK RAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
7-22 Section 7-7 - Troubleshooting Trees and Instructions
7-7-10 Network Troubleshooting
7-7-10-1 No Connection to the Network at All
1.) Check that the network cable between the scanner and the wall network is connected and well
seated in both ends. (Use a network cable that is known to be OK.)
2.) Check the cable between the network-connector on the Back Panel to the LAN-connector
on the GEF.
3.) Connect a network cable between your Scanner and your PC. Try to ping from the Scanner to the
IP address on the PC. If OK, the hardware connection inside the Scanner is OK.
7-7-10-2 GE remote service connection
The customer gets visual information about the network status.
The network status is defined as follows:
NOTE: The status is checked every 10 seconds, regardless whether you‘re in read or write mode.
BLACK - Cable disconnected or no network signal on a connected cable.
GRAY - Cable connected to a network. Does not imply proper network settings.
BLUE - One of the following processes is active: in.telnet.exe, in.ftpd.exe or WinVNC.exe.
These processes are used when remote access is active, so they are used as an indicator.
To Next Page
Loading...
