GE Voluson 730Pro - Peripherals Page; Printer Remote Control Selection

GE MEDICAL SYSTEMS - KRETZTECHNIK RAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
3-38 Section 3-7 - Printer Installation
3-7-5 Printer Remote Control Selection
To assign the Remote PRINT A key, Remote PRINT B key and Report Printer to desired Printer:
1.) On the control panel, press the UTILITIES key.
2.) In the “Utilities” menu on the left side of the screen select SYSTEM
to invoke the setup desktop.
3.) Select the
PERIPHERALS page.
• Remote Print A: Select the desired Printer for the remote control PRINT A
key.
• Remote Print B: Select the desired Printer for the remote control PRINT B
key.
NOTE: Optionally the Remote Control can be done by Foot switches.
Therefore select “Print A” or “Print B” in “Foot Switch Left” or “Foot Switch Right” - section.
• Report Printer: Select the desired Report Printer from the drop-down menu.
Figure 3-48 Peripherals page
NOTICE
The selected Report Printer is usually used for printing reports and images from Sonoview.
Foot Switch
Remote
Control
Report Printer
Print B
Print A