GE MEDICAL SYSTEMS - KRETZTECHNIK RAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
3-50 Section 3-12 - Network IP Address Configuration
Section 3-12
Network IP Address Configuration
NOTE: Following Information must be provided by customer or hospital engineer before you can start:
A Station name, AE Title, IP address and Port Number for the Voluson® 730Pro / 730ProV.
The IP addresses for the default gateway and other routers at the site for ROUTING
INFORMATION. Only if necessary (e.g. for Internet access).
1.) Press the UTILITIES
key on the Control panel once to display the Utilities menu.
2.) Select SYSTEM
and then open the NETWORK page on the System Setup desktop screen.
3.) Click the NETWORK CONFIGURATION
button, read the message and confirm with YES.
4.) The “Internet Protocol (TCP/IP) Properties” dialog page appears.
To specify a DICOM Address, follow the instructions of described in the Basic User Manual,
Chapter 17.3.7 of the Voluson® 730Pro / 730ProV.
Figure 3-51 Network Configuration
Figure 3-52 Internet Protocol (TCP/IP)
click Network Configuration button, read
message and afterwards confirm with Yes
You can get IP settings assigned automatically if
your network supports this capability.
You need to ask your network administrator for
the appropriate settings.
Type in:
• IP address
• Subnet mask
• Default gateway
NOTE:This example shows fictive numbers!
To Next Page
Loading...
