GE Voluson i BT06 - Connecting the External USB Hard Disk (Handydrive); Connection Directly to the Voluson I; Voluson E System; Voluson I; Voluson E Mounted on Dock Cart; Voluson I; Voluson E Mounted on Voluson Station

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-50 Section 3-5 - Connection of Auxiliary Devices
3-5-9 Connecting the external USB Hard disk (Handydrive)
3-5-9-1 Connection directly to the Voluson i / Voluson e system
The external “Handydrive” HDD may be connected to the USB ports on the rear connectors panel.
An external USB Hard disk can be connected once the system is powered ON, or after shutdown.
The Voluson i / Voluson e, Windows detects the device and automatically installs a driver. During this
process several dialogs may pop up, starting with the „Found New Hardware“ dialog.
NOTE: Memory drives or sticks may be sensitive to EMC interference.
This may affect system performance and/or image quality.
3-5-9-2 Connection via USB hub
As above. If applicable, the USB hub must be powered via the isolation transformer.
3-5-9-3 Voluson i / Voluson e mounted on Modo Cart
As above.
3-5-9-4 Voluson i / Voluson e mounted on Dock Cart
As above.
3-5-9-5 Voluson i / Voluson e mounted on Voluson Station
As above.
Figure 3-64 Connection Scheme - external USB HDD (Handydrive)
NOTICE
!! NOTICE:
Before disconnecting an external the system has to be informed about the removal of the device!
Operation see: Section 3-5-5-2 "External USB-Devices - Disconnection" on page 3-44.
USB cable