GE Voluson i BT06 - Wireless Network Configuration

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-110 Section 3-11 - Connectivity Setup
3-11-1-7 Wireless Network Configuration
The following procedure is used to configure the Voluson i / Voluson e system for a wireless network
environment.
1.) Connect the Wireless Network adapter/ Wireless Network Interface as described
in Section 3-5-4 on page 3-43.
2.) Press the UTILITIES
key on the keyboard once to display the Utilities menu.
3.) Select SYSTEM
and then open the NETWORK page on the System Setup desktop screen.
4.) Click the WLAN CONFIGURATION
button.
The
CURRENT STATUS of the selected Profile is displayed, as shown in Figure 3-129 below.
NOTICE
!! NOTICE:
To configure the Voluson i / Voluson e ultrasound unit to work with the WLAN adapter /
WLAN Interface, the hospital´s network administrator must provide the required information.
Figure 3-128 WLAN Configuration
Figure 3-129 Current Status
[WLAN Configuration]
button
NOTE:
This example shows
fictional information!
currently active profile
WLAN frequency
assigned IP address
current strength of
the WLAN signal