GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-11
3-4-1 Verify Customer Order and Inspect Components (cont’d)
• Optional: Visually inspect the Voluson Station components using the following checklist.
NOTE: Report any items that are missing, back-ordered, or damaged, to your GE sales representative. The
contact address is shown in Contact Information on page 1-18.
Table 3-8 Damage Inspection Checklist - Voluson Station (optional)
Step Item Recommended Procedure
1
Main label Enter Serial Number: __________________________ (printed on main label)
2
Probe Holders Clean the gel wells with warm water and a damp cloth to remove all traces of gel.
3
Covers Check that all screws are in place, all chassis and internal covers are installed.
4
Transformer
Check the power supply connectors and the associated cabling for good connection and proper
insulation. Japan only: Exchange pull out protection of main power cord.
5
Power Cord
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or any deterioration.
Verify continuity.
6
Front Castors
Check that the front castors can swivel, and can be placed in the locked position by pressing the foot
brake lever n each castor.
7
Rear Castors Check that the rear castors can roll and swivel.
8
Voluson Station
Voltage
Verify that the voltage of the optional Voluson Station is correct.
see: Section 3-4-4 "Dock Cart / Dock Cart light / Voluson Station Voltage Configuration" on page 3-21
To Next Page
Loading...
