GE Voluson P6 BT16 - 3-13-2-6 Removing a WLAN Profile; 3-13-2-7 Customizing an existing WLAN Profile

GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 3 - Setup Instructions 3-79
3-13-2-6 Removing a WLAN Profile
1.) Press the “Utilities” key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see Section Figure 3-76 on page 3-75
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
5.) Select the Security tab and then click Remove.
3-13-2-7 Customizing an existing WLAN Profile
1.) Press the “Utilities” key on the control console.
2.) On the right side of the screen select Connectivity and then click the Device Setup tab.
3.) Click the WLAN Configuration button; see Section Figure 3-76 on page 3-75
4.) The Wireless Network Configuration tool with available Wireless Networks appear.
5.) Select the Security tab and then click Customize.
6.) Customize the following information:
- Network Name(SSID)
- Check box “ Connect even if Network is not Broadcasting its Name (SSID)”
- network Authentication (Open, Shared key, WPA PSK or WPA2 PSK)
- Date Encryption
-Network Key
- Key Index
7.) After you have filled in all the required information, click OK.
Figure 3-80 Security - Customize