– 25 –
Sump Hose
Drain Pump
Disconnect
To remove the pump:
Note: Water will remain in hoses even when the tub
appears empty. Use care to avoid water spills.
Disconnect power to the machine.1.
Lower the drain hose into a small bucket to 2.
remove any water remaining in hose.
Remove the front panel. (See 3.
Front Panel.)
Disconnect the pump wire harness.4.
Pinch off the black sump hose to prevent water 5.
spills.
Remove hose clamps and hoses from the pump.6.
Remove two 3/8-in. hex-head screws.7.
Belt Install Tool Kit
To replace the drive belt using the tool kit:
Note: If not using the belt install tool, follow steps 1
through 3, and 6 through 7. Remove wire tie after
step 7.
Disconnect power.1.
Remove the front panel. (See 2. Front Panel.)
Center belt on drive pulley and secure tightly 3.
with wire tie as shown on following page. Align
wire tie as shown.
Stretch the belt install tool to fi t over the end of 4.
the motor shaft. (See Figure A.)
Slide belt install tool upward until it snaps into 5.
the fi rst groove of the motor shaft. (See Figure
B.)
Center belt on motor shaft grooves and slowly 6.
turn drive pulley clockwise.
Continue rotating drive pulley until belt is fully 7.
engaged.
Remove wire tie and belt install tool.8.
Belt
Since the belt provides constant tension, there is •
no need for adjustments (an adjustment method
is not provided).
A worn or damaged belt can result in excessive •
brake time and will initiate a motor inverter
slipping belt error code. This code will prevent
the motor/inverter from operating.
To replace the drive belt it may be helpful to use •
the belt install tool (part number WX05X10102).
(Continued next page)
To Next Page
Loading...
