GE WSXH208 - Location and Rough-In Dimensions

Installation instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) K_r proper
washer operation.
2. In an area where it will come in conti_ct with curtains
or drapes.
3. On carpet. The floor MUST be a hard surface with
a maxinmm slope of 1/2" per fbot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce tile floor.
IMPORTANT:
Minimum Installation Clearances
* When installed in alcove: Sides, Real,
Top = 0" (0 cm)
* When installed in closet: Sides, Real,
Top = 0" (0 cm), Front = 1" (2.54 cm)
* Ck)set door ventilation openings required:
2 louvers each 60 square ill. (387 cm2), located 3"
(7.6 cm) flom top and bottonl of door
Undercounter Installation
If an undercounter* installation is desired, you MUST
3_
install a top sheet ]<it, 14-A0, /. This ]<it is available through
your GE remileI:
*Custonl-sized countertop is required.
Mobile Home Installation
Installation must confbHn to Standard for Mobile Homes,
ANSI A119.1 and National Mobile Home Construction
and Safety Standards Act of 1974 (PL93-383).
ROUGH-IN
17
(43.2)
%
(1.9)
inch (cm)
36
(91.5)
Under
Counter
34%
(87.9)
DIMENSIONS
2435
(62.9)
SiDE
Adjustable Legs
26% _,
113/4(67.9)
(29.8) _,
_ r---
1½ A<_
Power
Cord
33V2
(85)
2%
(7.3)
Water
inlets
31%
(80.3)
12