Pairing the two GEEMARC CL7400 headsets
Choose one of the bases to act as transmitter/connector for your TV. One of the two headsets is
already pre-configured for the chosen base, so you only need to register the second headset. To do
this, repeat the registration procedure on page 12 of your user manual.
➔ Press the 'PAIR' button on the back of the base/charger stand for 3 seconds, then press the
headset's 'ON/OFF' button for 5 seconds.
➔ You'll know your headset is paired when both LEDs are green.
To Next Page
Need help?
General
