110 918496/GP0313
Changing Engine Oil and Filter
Change the engine oil and filter after the
first 50 hours of use, and every 250 hours
thereafter.
1. Position the machine on a level sur-
face.
2. Perform the “Mandatory Safety Shut-
down Procedure” on page 10.
3. Wait until the machine has cooled. See
“Service Safety Practices” on page 16.
4. Remove the engine access panel (A,
Fig. 74).
Notice: Removing engine access panel requires two people.
5. Position a waste oil collection con-
tainer to catch draining oil (B, Fig.
75).
Important: Dispose of waste engine oil
according to environmental laws or take
to a recycling center for proper disposal.
DO NOT pour waste engine oil onto the
ground or down a drain.
6. Remove the drain plug (C, Fig. 76)
from the oil pan and allow the oil to
drain into the waste oil collection con-
tainer.
7. Remove the oil filter, using a filter
wrench as necessary.
8. Put clean oil on the new oil filter
gasket. Install the filter and tighten 3/4
turn past the point where the gasket
contacts the filter head.
9. Reinstall and tighten the drain plug.
10. Reinstall the engine access panel (A,
Fig. 74).
Notice: Reinstalling engine access panel
requires two people.
Figure 74 – Engine Access
Panel
A
Figure 75 – Waste Oil Collec-
tion Container
B
Figure 76 – Oil Pan Drain Plug
C
https://tractormanualz.com/
To Next Page
Loading...
