128 918496/GP0313
Brake Fluid Reservoir (AL 300, AL 400 and AL 500
Series)
Checking Brake Fluid Reservoir Level
1. Perform the “Mandatory Safety Shutdown Procedure” on page 10.
2. Open the engine hood.
3. The brake fluid reservoir (G, Fig. 99)
is located against the platform at the
front of the engine compartment.
Note: On machines equipped with air
conditioning, the brake fluid reservoir
is located on the back of the air condi-
tioning enclosure.
4. Carefully remove the brake fluid res-
ervoir fill cap (H). Be careful not to
allow dirt to fall into the reservoir.
5. The brake fluid reservoir fluid level
should not fall below 1/2 full. Add
automatic transmission fluid as
required.
Wheels and Tires
Wheel Fasteners
Wheel fastener torque must be checked
before initial operation and every two
hours thereafter until the wheel mounting
hardware torque stabilizes. Torque the
wheel fasteners in the order shown (Fig.
100). When tires are removed and
replaced, this procedure must be repeated.
See “Wheels” on page 38 for wheel
fastener torque specifications, wheel rim
dimensions and wheel offset
measurements.
Figure 99 – Brake Fluid
Reservoir (AL 500 Series with-
out Air Conditioning Shown)
G
H
Figure 100 – Wheel Fasteners
Tightening Order
4
2
5
3
6
1
https://tractormanualz.com/
To Next Page
Loading...
