918496/GP0313 139
Control Modules
The control modules, located behind the
operator’s seat on the right, (all models
except AL 100 Series), or under the
operator’s platform (AL 100 Series)
provide switching, control logic and
diagnostic functions.
Machine Control Module
The machine controller (N, Fig. 110)
provides the following functions:
• Glow plug control
• Starter logic
• Sends forward/reverse signal to
drive controller
• Safety logic control
Drive Control Module (AL 500/400
Series)
The drive control module provides computerized control of the drive system, and
provides error-reporting functionality.
LEDs inside the cover indicate the following:
• Green steady on — Indicates power to the drive controller
• Red/green flashing — Indicates an error in the system
Figure 110 – Control Modules
N
P
Z
https://tractormanualz.com/
To Next Page
Loading...
