68 918496/GP0313
5. Place forward/reverse drive switch
(Fig. 25) on the top of the joystick
into the neutral position.
6. Turn the ignition key to the “I” (Run)
position (Fig. 26).
7. When the pre-heat indicator light (B,
Fig. 26) goes off, turn the ignition
key to the “II” (Start) position.
Release the key when the engine
starts.
8. If the engine does not start after 15
seconds, turn the key back to the “0”
(off) position, wait one minute and
repeat steps 6-7. If the engine does
not start after several attempts, see
“Troubleshooting” on page 153.
Note: Return switch to the “0” position
between starting attempts.
9. Immediately after starting the
engine, all warning indicator lamps
should go off (see “Warning Indicators” on page 58).
10. Proceed to “Warm-up” on page 69.
Figure 25 – Drive Direction
Figure 26 – Ignition/Pre-Heat
0
I
II
B
https://tractormanualz.com/
To Next Page
Loading...
