88 918496/GP0313
Auxiliary Hydraulics Connections
Important: Relieve pressure in the auxiliary hydraulic circuit before connecting /
disconnecting hydraulically powered attachment hoses. See “Auxiliary Circuit
Pressure Relief” on page 86.
Important: Be sure that the hydraulic connections are clean. Hydraulic oil
contamination can damage the hydraulic system.
If a Power-A-Tach
®
system hitch is installed,
connect the auxiliary hydraulic connections to
the attachment after connecting the attachment to the Power-A-
Tach
®
system hitch. Disconnect the auxiliary hydraulic connections
before disconnecting the attachment from the Power-A-Tach
®
system hitch.
To connect: Press the hose connections firmly down into the auxiliary hydraulic
connections until they snap into place.
To disconnect: Push down on the locking
rings (N, Fig. 55) until the hose
connections release.
Important: Always cap the hydraulics
(Fig. 39) after disconnecting, to protect
against hydraulic oil contamination.
Note: Connect attachment connectors
together when the attachment is not being
used, to keep pressure from building in
the attachment and to keep the connector
mating surfaces clean.
Figure 55 – Auxiliary Hydraulic
Connections
N
https://tractormanualz.com/
To Next Page
Loading...
