54 50940193/DP0415
If the LCD is broken, care must be taken with any
leaking fluid. If LCD fluid gets onto your skin, wipe
with a cloth and wash the area with mild soap and water. If LCD fluid
gets into your eyes, thoroughly rinse your eyes with clean water for
several minutes and seek medical assistance. If LCD fluid is swallowed,
rinse your mouth thoroughly with clean water, then drink a substantial
volume of water and induce vomiting. Then seek medical assistance.
Information Center Electronic Display Symbols
The following table describes symbols used in the information center electronic display.
Note: Values may not display for all parameters, depending upon installed options and
equipment.
O. Regen/Return Button – Used for different
functions depending upon screen and context:
• Switches to the Regen display mode if the
symbol is displayed on the screen. Also initiates
DPF regeneration if all appropriate conditions
are met.
• Used to return to previous screen. Corresponds
to the symbol on the display screen.
R. Regen Inhibit Button (DPF models) – Press for
5 seconds to inhibit DPF reset regeneration.
Displays the symbol.
Table 6: Symbols Descriptions
Symbol Description Symbol Description
Engine crankshaft revolutions per
minute.
Real-time fuel consumption rate.
Displayed in gallons/hour (SAE) or
liters/hour (METRIC).
Accumulated operation time. Time
is displayed in hours, and
accumulates when the engine is
running.
Display brightness increase. Press
button (P, Figure 20) when this
symbol is displayed to increase
screen brightness.
Battery charging circuit voltage.
Display brightness decrease. Press
button (Q, Figure 20) when this
symbol is displayed to decrease
screen brightness.
Fuel level in fuel tank.
Return to previous. Press button (O,
Figure 20) when this symbol is
displayed to return to the previous
screen.
Coolant temperature.
Diesel Particulate Filter (DPF)
regeneration (DPF Models). See
“Diesel Particulate Filter (DPF)
Regeneration Procedures (DPF
Models)” on page 116.
To Next Page
Loading...
