Gehl R135 - Travel Drive, Lift, and Tilt Control Systems

61 50940193/DP0415
Travel Drive, Lift and Tilt Controls
Skid-Steer loaders are equipped with one of three control systems:
• T-Bar Controls: see “T-Bar Controls” on page 61.
• Joystick Controls: see “Joystick Controls” on page 64.
• Hand and Foot Controls: see “Hand and Foot Controls” on page 67.
T-Bar Controls
On T-bar-equipped machines, the left T-bar controls the travel drive, and the right T-bar
controls the attachment lift and tilt.
Table 8: T-Bar Controls
Ref. Control Description
A Left T-Bar
Controls drive forward, reverse, turn, and speed. See
“Drive Control (Left T-Bar)” on page 62.
B Right T-Bar
Controls lift arm raise/lower, float, and attachment tilt. See
“Lift/Tilt Control (Right T-Bar)” on page 63.
C Two-Speed Selection Button
Toggles between high- and low-speed travel modes. See
“Two-Speed Drive (Option)” on page 69.
D Horn Button Activates horn.
E Hydraglide™ Button
Activates Hydraglide™. See “Hydraglide™ Ride Control
System (Option)” on page 73.
F INACTIVE Button is inactive on T-Bar Controls.
G
Auxiliary Hydraulics Rocker
Switch
Controls auxiliary hydraulics flow direction and amount.
See “Auxiliary Hydraulic System” on page 79.
H
Auxiliary Hydraulics Continuous
Flow Latch Trigger
Works with Auxiliary Hydraulics Rocker Switch to latch/
unlatch auxiliary hydraulics continuous flow. See “Auxiliary
Hydraulic System” on page 79.
Figure 25 – T-Bar Hand Controls
D
C
G
E
F
H
Left T-Bar
Right T-Bar
B
A