80 50940193/DP0415
Auxiliary Hydraulics Control
Rocker switch (F, Figure 49) controls the
direction and amount of auxiliary hydraulics
flow.
Auxiliary hydraulics control is proportional:
the farther switch (F) is moved from center,
the higher the flow through the auxiliary
circuit. Flow direction is reversed when rocker
switch (F) is moved in the opposite direction.
To latch continuous auxiliary hydraulic flow,
hold rocker switch (F) fully on in either
direction and push and hold trigger button (G)
for five seconds. When the rocker switch and
trigger are released, continuous flow should be
enabled.
Note: Continuous flow amount is controlled
using engine speed.
To cancel continuous flow, either push trigger
button (G) or move rocker switch (F) in either
direction.
Figure 49 – Auxiliary Hydraulics
Control Rocker Switch
Right T-Bar
F
Right Joystick
F
Right Hand Control
F
G
G
G
To Next Page
Loading...
