Gehl RS5-34 - TILT CYLINDER INSTALLATION

RS5-34 Telescopic Handler TILT CYLINDER
PRINTED IN U.S.A. 604-4 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
TILT CYLINDER INSTALLATION
STEP 9
G0805221
Using a hoist and lifting strap, position the tilt cylinder
in the upper mounting bracket.
STEP 10
G0805219
Align the pivot pin retainer bolt hole with the holes in
the cylinder mount. Install the upper pivot pin.
STEP 11
G0805217
Install the retainer bolt (1) and nut (2) in the upper
pivot pin and tighten.
Remove the lifting strap and chain hoist from the tilt
cylinder.
STEP 12
Remove the caps and plugs from the fittings and
hoses.
STEP 13
G0805216
Reconnect the two hydraulic hoses to the tilt cylinder.
STEP 14
Start the engine. The park brake must be ON. Pull
back on the joystick to raise the boom approximately
2 feet (0.6 m). Shut off the engine.
STEP 15
Rotate the Dynattach ® and align the rod end of the
cylinder with the Dynattach
® cylinder mount.
1
2
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com