Gehl RS5-34 - EXTEND CYLINDER REMOVAL

RS5-34 Telescopic Handler BOOM EXTEND CYLINDER
PRINTED IN U.S.A. 608-2 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
G0805102
5. Locate the attachment boom “Retract” section on
the right side of the control valve and remove the
rubber boot. Using a screwdriver, turn the screw
IN (clockwise) until it bottoms, then turn it OUT
(counterclockwise) until it bottoms. Reinstall the
rubber boot.
EXTEND CYLINDER REMOVAL
NOTE: See Section 605 of this Service Manual for
the repair of this cylinder.
STEP 1
G0905040
Mark the hydraulic lines for correct assembly. Loosen
and remove the two lines from the extend cylinder.
STEP 2
Install caps and plugs on all hydraulic fittings to
prevent contamination of the hydraulic system.
STEP 3
G0905019
Using a hoist and lifting strap, position the lifting strap
around the extend cylinder base. Apply upward
pressure to remove the slack from the lifting strap.
STEP 4
G0905020
Remove the retainer bolt (1) and nut (2) from the
pivot pin at the base of the extend cylinder.
STEP 5
G0905022
Remove the pivot pin from the base of the extend
cylinder.
1
2
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com