Template Date: 1994_04_22
RS5-34 Telescopic Handler INTERMEDIATE BOOM
MANDATORY SAFETY SHUTDOWN
PROCEDURE
BEFORE cleaning, adjusting, lubricating, or
servicing this unit:
1. Stop machine on a level surface. (AVOID parking
on a slope, but if necessary, park across the
slope and block the tires.)
2. Fully retract the boom and lower the attachment
tool to the ground. Idle engine for gradual
cooling.
3. Place controls in neutral and apply parking
brake.
4. Shut off the engine and remove the key.
ONLY when you have taken these precautions
can you be sure it is safe to proceed. Failure to
follow the above procedure could lead to death or
serious bodily injury.
GENERAL INFORMATION
If slide pad replacement is required, see Section 707
of this manual for correct procedure.
INTERMEDIATE BOOM REMOVAL
STEP 1
G1005084
Remove the inner boom section from the
intermediate boom. See Section 703 of this manual
for correct procedure.
IMPORTANT:
If the slide pads are to be reused, they
must be marked as to location and direction (front/
rear/top/bottom) as they are removed. Wire tie the
shims with each pad. Slide pads and shims must be
reinstalled in their exact original position. Refer to
Section 707 of this manual for the correct procedure
to install new replacement slide pads.
STEP 2
G1005048
Loosen and remove the bolts (1) and lock plates (2)
from the two top slide pads on the rear of the
intermediate boom.
1
1
1
1
2
2
To Next Page
Loading...
