Template Date: 1997_02_12
RS5-34 Telescopic Handler TRANSMISSION
TRANSMISSION REMOVAL
STEP 1
Raise the telescopic boom enough to allow a hoist to
be used for transmission removal and installation.
Support the boom on a support stand.
MANDATORY SAFETY SHUTDOWN
PROCEDURE
BEFORE cleaning, adjusting, lubricating, or
servicing this unit:
1. Stop machine on a level surface. (AVOID parking
on a slope, but if necessary, park across the
slope and block the tires.)
2. Fully retract the boom and lower the attachment
tool to the ground. Idle engine for gradual
cooling.
3. Place controls in neutral and apply parking
brake.
4. Shut off the engine and remove the key.
ONLY when you have taken these precautions
can you be sure it is safe to proceed. Failure to
follow the above procedure could lead to death or
serious injury.
STEP 2
G0905065
Place a wheel chock in front of and behind at least
one tirel.
STEP 3
G0805075
Loosen the two thumbscrews (1) and remove the
battery access cover (2).
STEP 4
G0905001
Disconnect the negative (-) battery cable from the
battery.
STEP 5
G0905077
Remove the four screws (1) and the fuel filter access
cover (2).
1
1
2
1
1
1
1
2
To Next Page
Loading...
