Gehl RS6-34 - Front Axle Installation Steps

RS5-34 Telescopic Handler FRONT AXLE
PRINTED IN U.S.A. 503-5 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
STEP 23
G0905075
Remove the two axle mounting nuts and bolts
located in front of the axle.
STEP 24
G0905073
Have an assistant balance the axle on the floor jack
and lower the floor jack slowly and remove the axle
out from under the machine.
STEP 25
After the axle is removed, have adequate stands or
work surface to support the axle safety while
performing the repair procedure.
FRONT AXLE INSTALLATION
STEP 26
G0905073
Carefully roll the axle and floor jack under the
machine. Apply upward pressure to raise the axle
into position.
STEP 27
G0905076
Align the four bolt holes in the axle with the holes in
the frame. Install and tighten the four bolts and nuts
to 380 ft.-lbs. (515 Nm).
STEP 28
Lower and remove the floor jack.
STEP 29
Install both wheels and tires on the axle.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com