Gehl RS6-34 - Frame Leveling Cylinder Removal Steps

PRINTED IN U.S.A. 603-2 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
RS5-34 Telescopic Handler FRAME LEVELING CYLINDER
4. Locate the level right section on the left-hand
side of the main control valve and remove the
rubber boot. Using a screwdriver, turn the screw
IN (clockwise) until it bottoms, then turn it OUT
(counterclockwise) until it bottoms. Reinstall the
rubber boot.
G0805102
5. Locate the level left section on the right-hand
side of the main control valve and remove the
rubber boot. Using a screwdriver, turn the screw
IN (clockwise) until it bottoms, then turn it OUT
(counterclockwise) until it bottoms. Reinstall the
rubber boot.
NOTE:
See Section 605 of this Service Manual for
the repair of this cylinder.
FRAME LEVELING CYLINDER REMOVAL
STEP 1
G0805206
Place blocks on both sides between the frame and
the rear axle.
STEP 2
G0805207
Remove the bolt (1) and retaining pin (2) from the
lower pivot pin.
STEP 3
G0805208
Remove the lower pivot pin from the cylinder.
STEP 4
G0805209
Mark the leveling cylinder hydraulic hoses for correct
assembly location.
1
2
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com