Template Date: 1997_02_12
STEP 16
G0805215
Align the pivot pin retainer bolt hole with the holes in
the cylinder mount. Install the lower pivot pin.
STEP 17
G0805214
Install the retainer bolt (1) and nut (2) in the lower
pivot pin.
STEP 18
Use a grease gun with the specified grease to
lubricate the upper and lower pin grease fittings.
STEP 19
G0805077
With the park brake on and the engine running, fully
retract and extend the tilt cylinder several times to
remove any air from the system.
Lower the boom and shut off the engine. Check for
leaks. Correct any leakage found. Check the
hydraulic fluid level. If necessary, fill to the correct
level with the specified fluid.
2
1
To Next Page
Loading...
