Gehl RS6-34 - Cylinder Assembly Steps

RS5-34 Telescopic Handler CYLINDER REPAIR
PRINTED IN U.S.A. 605-5 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
Rac
0
-
00000
Template Date: 1997_02_12
CYLINDER ASSEMBLY
STEP 20
Clean the cylinder rod threads, rod nut and all
cylinder parts in solvent and dry with compressed air.
Inspect all parts for damage or wear. Replace
damaged or worn parts.
STEP 21
G1550MP
Inspect the cylinder barrel for nicks, scratches or
scoring prior to being assembled.
Use crocus cloth to remove any minor nicks or
scratches.
STEP 22
G1551MP
Inspect the cylinder rod for any nicks, scratches or
scoring. Roll the rod on a hard flat surface to check
for any bending.
STEP 23
G1549MP
If needed, install a new bushing in the base end and
the rod end of the cylinder.
STEP 24
G1547MP
Install a new inner seal (lip to the inside of the barrel)
in the head gland.
NOTE:
Lubricate all new seals with clean hydraulic
fluid or petroleum jelly before installation.
STEP 25
G1546MP
Install a new inner wear ring in the head gland.
ROD SEAL‘
WEAR RING
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com