Gehl RS6-34 - Lift Cylinder Removal Steps

RS5-34 Telescopic Handler LIFT CYLINDER
PRINTED IN U.S.A. 607-2 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
G0805102
5. Locate the attachment Boom Lower section
(second section) on the right hand side of the
control valve and remove the rubber boot. Using
a screwdriver, turn the screw IN (clockwise) until
it bottoms, then turn it OUT (counterclockwise)
until it bottoms. Reinstall the rubber boot.
LIFT CYLINDER REMOVAL
NOTE: See Section 605 of this Service Manual for
the repair of this cylinder.
STEP 1
G0805223
Mark the hydraulic hoses for correct assembly.
Disconnect the two hydraulic hoses from the lift
cylinder.
STEP 2
Install caps and plugs on all hydraulic fittings to
prevent contaminating the hydraulic system.
STEP 3
G0805224
Loosen and remove the retainer bolt (1) and nut (2)
from the lower pivot pin.
STEP 4
G0805225
Remove the lower pivot pin from the lift cylinder.
STEP 5
G0805226
Using a hoist and lifting strap, position the lifting strap
around the lift cylinder and apply upward pressure.
1
2
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com