Gehl RS6-34 - Lift Cylinder Installation Steps

RS5-34 Telescopic Handler LIFT CYLINDER
PRINTED IN U.S.A. 607-3 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
STEP 6
G0805227
Loosen and remove the retainer bolt (1) and nut (2)
from the upper pivot pin.
STEP 7
G0805228
Remove the grease fitting from the upper pivot pin
and remove the upper pivot pin.
STEP 8
Remove the lift cylinder from the machine using the
hoist.
NOTE:
If necessary, use this same procedure to
remove the opposite side lift cylinder.
LIFT CYLINDER INSTALLATION
STEP 9
G0805229
Using the hoist and lifting strap, position the lift
cylinder in the cylinder mounts.
STEP 10
G0805231
Install the grease fitting in the end of the pivot pin.
Align the pivot pin retainer bolt hole, with the hole in
the cylinder mount. Reinstall the upper pivot pin.
Use care not to damage the grease fitting.
2
1
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com