Gehl RS6-34 - Extend Cylinder Installation Steps

RS5-34 Telescopic Handler BOOM EXTEND CYLINDER
PRINTED IN U.S.A. 608-4 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
EXTEND CYLINDER INSTALLATION
STEP 10
G0905028
G0905029
Position the extend cylinder in place and install the
pivot pin in the rod end of the extend cylinder.
NOTE:
Align the pivot pin holes with the holes in the
cylinder mount.
STEP 11
G0905030
Install the retainer bolt (1) and nut (2) and tighten.
Remove the hoist and lifting strap.
STEP 12
G0905032
Position a hoist and lifting strap around the base of
the extend cylinder. Apply upward pressure until the
hole in the base is aligned with the mounting bracket.
STEP 13
G0905033
Install the pivot pin in the base of the extend cylinder.
NOTE:
Align the pivot pin holes with the holes in the
cylinder mount.
1
2
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com