Gehl RS6-34 - Inner Boom Removal Steps

RS5-34 Telescopic Handler INNER BOOM
PRINTED IN U.S.A. 703-2 913241
Template
Name:
OML
_
2
_
col
Rac
0
-
00000
Template Date: 1997_02_12
Alt
=
to
hide
template
information
Alt+ to display template information
G0805102
6. Locate the attachment Tilt-Down section (rear
section) on the right side of the control valve and
remove the rubber boot. Using a screwdriver,
turn the screw IN (clockwise) until it bottoms,
then turn it OUT (counterclockwise) until it
bottoms. Reinstall the rubber boot.
RELIEVING HYDRAULIC PRESSURE
FROM THE BOOM EXTEND CYLINDER
g0805101
7. Locate the attachment Boom-Extend section
(third section) on the left side of the control valve
and remove the rubber boot. Using a
screwdriver, turn the screw IN (clockwise) until it
bottoms, then turn it OUT (counterclockwise)
until it bottoms. Reinstall the rubber boot.
G0805102
8. Locate the attachment Boom-Retract section
(third section) on the right side of the control
valve and remove the rubber boot. Using a
screwdriver, turn the screw IN (clockwise) until it
bottoms, then turn it OUT (counterclockwise)
until it bottoms. Reinstall the rubber boot.
GENERAL INFORMATION
If slide pad replacement is required, see Section 707
of this manual for correct procedure.
INNER BOOM REMOVAL
STEP 1
G1005038
Loosen and remove the nuts from each clevis that
secure the double chain to the outer boom.
STEP 2
Position both ends of the double chain over the front
of the inner boom.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com