Lift/Tilt Control
Moving the lift arm and tilting the attachment are accomplished by rotating
the control handles. To raise the lift arm, rotate the left control up; to lower
the lift arm, rotate the left control down. To tilt the attachment downward,
rotate the right control up; to tilt the attachment up or back, rotate the right
control down..
Note: The speed of the lift/tilt motion is directly proportional to the amount of
control movement and engine RPM.
To place the lift arm in the detent (float) position, push the left control all the
way down, into the detent. This position allows the lowered lift arm to float
while traveling over changing ground conditions.
Never push the lift/tilt control into the float position
with the attachment loaded or raised, because this will cause the lift arm to
lower rapidly.
908268/BP0904 28
WARNING
To Next Page
Loading...
