2-78
Move the machine at least once a month to form new oil
films on all the moving parts during long-term storage, and
recharge the battery at the same time.
IMPORTANT
When reusing a machine that has been stored for a
long time without receiving antirust treatment once a
month, consult your dealer.
To use the machine again after a long period of storage,
follow the procedure below:
• Wipe antirust off the hydraulic cylinder rods.
• Apply generous amounts of grease or oil to the moving
parts.
• Drain water from the fuel tank, the engine oil pan and the
hydraulic oil tank by opening the drain cock and remov-
ing the drain plugs.
• After starting the engine, warm-up the machine before
use.
16-2. Storing
When you have to operate the machine indoors for
the antirust procedure, be sure to ventilate the
area well by opening windows and doors to pre-
vent asphyxiation.
16-3. Using the machine again
Courtesy of Machine.Market
To Next Page
Loading...
