25. Procedures for Maintenance
3-35
Check the items described here every day, before starting the engine for the first time.
25-3-1. Checking and replenishing the cooling water
1) Open the engine hood to check that the cooling water
level is between the FULL and LOW marks on the sub-
tank (1) (illustrated at the right). If the cooling water level
is low, add cooling water to the FULL mark through the
port of the sub-tank (1).
For the cooling water to be used, refer to Section "21.
Fueling, Oiling and Greasing Based on Temperature
Range".
2) Securely close the cap after replenishing.
3) If the sub-tank is empty, check the sub-tank for leaks
and then check the cooling water level in the radiator. If
the cooling water is insufficient, refill the radiator and
then the sub-tank with cooling water.
4) If the cooling water level is proper, close the engine
hood.
25-3. Checking before start-up
Normally do not open the radiator cap.
Check the cooling water in the sub-tank when the
engine is cool.
LOW
FULL
(1)
020174-00X
Courtesy of Machine.Market
To Next Page
Loading...
