25. Procedures for Maintenance
3-47
8) When mounting the new filter cartridge, turn it 2/3 of a
turn after the seal surface has contacted the filter
mount.
9) After replacing the oil filter cartridge, add engine oil up
to the upper limit mark on the oil dipstick (G) through the
oil supply port (F).
Refer to Section "21. Fueling, Oiling and Greasing
Based on Temperature Range" for the fuel to be used.
10) Idle the engine for several minutes and then stop the
engine. Then check that the oil level exceeds the mid-
point between the upper and lower limit marks on the
oil dipstick.
Refer to Section "25-3. Checking before start-up".
11) Install and tighten the oil supply port cap securely.
Replace the engine oil and the oil filter 6 months after the
previous replacement, even if the service hours have not
reached 200 service hours.
Also replace them at 200 service hours, even if 6 months
have not elapsed since the previous replacement.
(F)(G)
020218-00X
Courtesy of Machine.Market
To Next Page
Loading...
