13. Operating Instructions
2-35
13-4-2. Traveling in reverse
1) Pull the accelerator lever (1) back to the "RUN" position
to increase the engine speed.
2) Unlock the lock levers (2), and retract the implement to
raise it 16 to 20 in. (40 to 50 cm) above the ground.
• Always check the position of the blade before
operating the travel levers and pedals.
When the blade is in the rear, the travel levers
and pedals operate in the reverse of the normal
operation.
• A signal person should be in attendance to give
signals at sites which are dangerous or not clear-
ly in view of the operator.
• Clear all people from the working area.
• Sound the horn before beginning travel, to alert
the people near the machine.
• Clear obstacles from the path of the machine.
• There is a blind spot behind the machine. Make
sure that no people are in the blind spot before
traveling backwards.
• Do not operate the travel levers and pedals rap-
idly while the engine is running at high speed.
Otherwise, the machine may move unexpectedly,
causing a serious accident.
020330-00X
(1)
(2)
(4)(5)
(3)
(2)
(2)
020325-00E
Idling
Run
(1)
Unlock
(Left side)
(2)
020340-00E
Courtesy of Machine.Market
To Next Page
Loading...
