Gehl Z17 GEN:2 - 13-19. Inspection requirements after stopping the engine; Check oil and water for leaks; 13-20. Locking; Lock the fuel supply port cover and engine hood.

13. Operating Instructions
2-57
1) Check oil and water for leaks, and visually inspect the
implement, the machine, and the undercarriage by
walking around them.
If there are any leaks of oil or water, or any observed ab-
normality, take corrective action.
2) Completely fill the fuel tank.
3) Confirm that the engine compartment is free of any for-
eign matter.
Combustibles or dust in the engine compartment may
cause a fire. Remove them, if any.
4) Remove mud adhering to the undercarriage of the ma-
chine.
Make sure that you lock the following :
(1) Cover for fuel supply port
(2) Engine hood
Note :
The starter switch key (1) is used to lock all of the items
mentioned above.
13-19. Inspection requirements after stopping the engine
13-20. Locking
(1)
020374-00X
(2)
020375-00X
Courtesy of Machine.Market